Out Front: Water Service & Irrigation

At the curb, the water setup tells its story. The buried cleanouts are visible, which is good news for future maintenance. The main shutoff is an older gate valve, common in the ’90s, and functional for now. A more modern quarter-turn ball valve offers a smoother, more reliable shutoff, but that’s more of a modernization note than a defect.

The water heater connection shows a PEX update, though the bonding wire was removed in the process, a small detail, but one that matters for safety and proper grounding. The irrigation system ran on command, though a steady backyard leak was visible during testing. No on-site timer was found, so the system’s likely controlled manually or from a previous owner’s timer that’s long gone.

Electrical, Roof & Exterior Details

Along the side yard, a 200-amp service panel holds mostly original breakers with a few Square D upgrades. Several circuits aren’t labeled, which can slow future troubleshooting. The A/C breaker is currently at 35 amps, while the condenser’s data plate calls for 30, a mismatch worth adjusting during maintenance.

Up top, the tile roof has that unmistakable late-’90s look: no bird blocking or eave riser, underlayment curling and exposed, and a few prior patch repairs visible from below. Nothing catastrophic, but this is the stage where underlayment starts aging out.

The walkways are mostly level, save for one trip bump, and the side gate doesn’t have a self-closing hinge, a key safety item since there’s a pool immediately behind it.

Ventilation & HVAC Performance

Attic airflow deserves a mention here. Several soffit vents are partially blocked by insulation baffles installed too tight to the openings, which limits the intake air that attic ventilation depends on. Outside, a Lennox 3-ton system from around 2019 or 2020 runs well. Sealing the line-set wall penetration would help keep pests from finding an easy path inside.

This house would also benefit from reopening the backyard swale and adding gutters, two small drainage tweaks that make a big difference in keeping the slab dry over time.

Inside the Home

Stepping inside, the place shows care and effort: fresh paint, cool air, and minimal wear. Still, a few small annoyances stood out. Several blinds have lost their spring tension, the kitchen island countertop is a bit loose, and there’s no fridge water line, not a defect, just something to plan for if you want an ice maker.

In the bathrooms, one sink tailpiece was dripping slowly, and a scorched outlet on a GFCI-protected circuit should be replaced before use. The smoke and CO alarms, updated in 2020, are operational; I also re-clicked a loose interconnect so the system communicates properly.

The laundry area sits inside the garage, a smart use of space, but without a vent fan or openable window, expect some lingering humidity when the dryer’s running.

Garage, Pool & Structure

The garage slab shows a slight mid-span heave. The door still seals, but the raised center can create small gaps at the edges over time. Expansion joints are visible and should remain sealed to reduce water migration.

Out by the pool, the equipment runs, but the in-floor pop-ups aren’t cycling through all zones correctly. The aerator is strong, maybe too strong, and labeling those pool valves would help everyone know what’s what when it’s time to backwash or adjust flow.

My Thoughts

For a 1998 build, this Surprise home tells a familiar Arizona story: solid bones, aging systems, and a few details ready for a tune-up. Tile roofs and attic ventilation need ongoing attention in our climate, and moisture management, both above and below, will keep the structure strong for decades more.